see the original item page
in the repository's web site and access all digital files if the item*
share




1993 (EN)
Compatibility of tolerancing (EN)

Sfantsikopoulos, MM (EN)

N/A (EN)

Tolerances are assigned to a mechanical engineering design either on the basis of functional and/or manufacturing requirements (toleranced dimensions, geometrical tolerances) or on the basis of the general categories-fine, medium, coarse-of the international standards or the designer's knowledge and experience (untoleranced dimensions). Conventional dimensions of the currently applicable dimensioning rules and implicit dimensions, including those attributed to geometrical tolerances, thus create four groups of tolerances which may or may not be compatible. In addition, any tolerance compromise, however tedious and difficult, not achieved systematically may well lead to accuracies which cannot be produced by the available machine tools. In the paper, a systematic approach to the above problems is presented. A methodology is demonstrated for the verification of the tolerance compatibility and for the assignment of compatible, producible and cost optimum tolerances. © 1993 Springer-Verlag. (EN)

journalArticle

Manufacturing tolerances (EN)
Design tolerances (EN)
Tolerance compatibility (EN)
Tolerancing (EN)

Εθνικό Μετσόβιο Πολυτεχνείο (EL)
National Technical University of Athens (EN)

The International Journal of Advanced Manufacturing Technology (EN)

1993


Springer-Verlag (EN)



*Institutions are responsible for keeping their URLs functional (digital file, item page in repository site)