The effect of surface preparation on the behaviour of double strap adhesive joints with thick steel adherents (EN)

Anyfantis, KN (EN)

Tsouvalis, NG (EN)

One of the major factors determining the integrity of an adhesive bond is the preparation of the bonding surfaces. The present study is an experimental investigation of the effect of the surface preparation procedure on the response of a steel-to-steel double strap adhesive joint. Two procedures for preparing the bonding surfaces are investigated, namely grit blasting (GB) and simple sandpaper (SP). The behaviour of the joints, in terms of the force-displacement and strains-displacement responses was monitored and compared for both cases. The joints with SP surface preparation exhibited slightly lower stiffness and lower strength than the joints with GB surface preparation, while the latter failed at a lower displacement. In both cases, failure initiated at the free edges of the joints and the dominating failure mode was interfacial. In addition to the above experimental measurements, results are also presented from the application of a properly modified analytical model. © 2009 Taylor & Francis Group, London. (EN)

conferenceItem (EN)

Structural design (EN)

Force-displacement (EN)

Free edge (EN)

Steel (EN)

Bonding surfaces (EN)

Experimental measurements (EN)

Grit blasting (EN)

Adhesive bond (EN)

Analytical model (EN)

Displacement response (EN)

Ocean structures (EN)

Failure analysis (EN)

Experimental investigations (EN)

Surface preparation (EN)

Adhesive joints (EN)

Εθνικό Μετσόβιο Πολυτεχνείο

Ψηφιακό Αποθετήριο της Κεντρικής Βιβλιοθήκης του ΕΜΠ | Dspace@NTUA

Κεντρική Βιβλιοθήκη Ε.Μ.Π.

Ιδρυματικό Αποθετήριο

Δημοσιεύσεις μελών Δ.Ε.Π. σε συνέδρια

Proceedings of MARSTRUCT 2009, 2nd International Conference on Marine Structures-Analysis and Design of Marine Structures (EN)

2009 (EN)

http://hdl.handle.net/123456789/35863

387 (EN)

392 (EN)